The R2-500X4 Prime Series car power amplifier from ROCKFORD FOSGATE is known for its exceptional performance. With 4 channels, this power amplifier is specifically designed to operate in stereo at 4 Ohms/2 Ohms. It can also operate in mono at 4 Ohms (in combined mode) to connect two subwoofers.

The class D amplification technology of this power amplifier stands out for its ability to reduce the electrical demand of the system while ensuring optimal performance. Additionally, it incorporates the C.L.E.A.N. technology that produces a distortion-free signal and facilitates gain adjustment through its clipping signal LED indicator.

Features:

• 4 channels
• 300 W RMS / 500 W peak
• High/low pass filter on front and rear channels (50-250Hz, 12 dB/octave)
• Equipped with C.L.E.A.N. technology. (Calibrated Level Eliminates Audible Noise)
• Can power 4 full-range speakers or 2 subwoofers

Specifications:

• Power wire gauge: 4 AWG
• Speaker wire gauge; 8AWG
• Input and output connector: Compression terminal block
• Frequency response: 20Hz - 20kHz
• Operating voltage: 9V - 16V
• Recommended fuse (not included): 80A

Nominal power:

• 75 watts x 4 channels at 4 Ohms
• 125 watts x 4 channels at 2 Ohms
• 250 watts x 2 channels at 4 Ohms bridged / mono

Dynamic power:

• 90 watts x 4 channels at 4 Ohms
• 160 watts x 4 x channels at 2 Ohms
• 300 watts x 2 channels at 4 Ohms bridged / mono

Signal input:

• Front low level: 4 RCA
• Front high level: Molex 4 pin
• Rear low level: 4 RCA
• Rear high level

Output signal:

• Low Level: 2 RCA (Active Pass-Thru with RCA or Hi-Level input)