This startup kit fully equips you so you can start learning how to use Arduino smart plates! Go to Arduino.cc guide page to begin. You can also register on the official forumand on the « Project Hub » to learn even more and share!

Modules: 

• IR REmote Control / Photo transitor / IR Diode
• UNO R3 Surface Mount with USB cable
• Single Joystick
• 16 buttons
• RTC/Real Time Clock 
• 1602A LCD
• Single Relay
• Micro Servo SG90 Motor
• RFID Modeule with key
• ULN2003AN wih stepper motor module
• Water sensor
• Electret Micro
• DHT11 Temperature Sensor
• RGB LED (with resistors)

Parts:

• 1 x UNO R3 Development Board
• 1 x USB Male to Type B Male Cable
• 1 x 65 Piece Jumper Cable Set
• 1 x 830 Point Breadboard
• 15 x LED Diode (Red, Green, Yellow)
• 30 x Resistors (5 x 220R, 5 x 10K, 5 x 1K)
• 1 x 10 Pin DuPont Male to Female Cable
• 1 x Potentiometer Module
• 1 x Active Buzzer Module
• 1 x Passive Buzzer Module
• 1 x 74HC595N Shift Register IC
• 1 x Infrared Receiver
• 1 x LM35DZ Temperature Sensor
• 1 x Flame Sensor
• 1 x Roll Ball Switch
• 1 x 5mm LDR
• 5 x Button Switch with Caps
• 1 x Infrared Remote Control
• 1 x Single Digit Tube Display
• 1 x Four Digit Tube Display
• 1 x 8 x 8 Dot Matrix Tube Display
• 1 x UNL2003 Driver Board
• 1 x 5V Stepper Motor
• 1 x SG90 Servo Motor
• 1 x 1602 IIC 12C LCD Display Module
• 1 x Joystick Module
• 1 x DHT11 Temperature and Humidity Sensor
• 1 x Water Level Sensor
• 1 x RFID Module
• 1 x RFID FOB Key
• 1 x RFID Card
• 1 x Single Channel Relay Module
• 1 x RTC (Real Time Clock) Module
• 1 x 16 Button Matrix Keypad
• 1 x RGB Three Colour Module
• 1 x 9V Battery Snap